Intermatic Power Failure Lighting

Intermatic Power Failure Lighting

These power failure lights provide light throughout the home, office, school, hotel, ect... during power outages. Night light feature provides sufficient light in room and down hallways late at night. During power failure mode, three high-intensity white LED's are driven to full brightness. While still offering the same features, the EL200 series effectively replaces a 15 amp receptacle and the EL300 series effectively replaces a 15 amp single pole switch. Commercial grade models interface with Fire and Smoke Alarm products.

The EL100 unit can be operated in Five different modes. NOTE: After installation, the battery reaches maximum charge in about one week.
Night Light ON - Press the lens once when the night light is OFF and the night light will come ON at 25% of full brightness. In this mode the night light is powered by the building current.

Night Light OFF - Press the lens once when the night light is ON and the night light will power OFF.
Power Failure Light ON - When building current is disconnected (e.g., during a power failure), the power failure light will automatically come ON at 100% of full brightness and remain lit until the battery is discharged (4 hours at a full charge). NOTE: As the battery runs out of power, the unit will begin to flash and will continue to do so until all power is drained from the battery or power is restored.
Power Failure Light OFF - When the light is ON (and the unit is operating on battery power), press and hold the lens for 5 or more seconds to manually turn it OFF. NOTE: You can press and hold the lens again for 5 or more seconds to turn the power failure light back ON.
Battery Test - After battery has had a minimum of 1 week to charge, press and hold the lens for 5 seconds to switch the unit from building current to battery power, which turns ON the light at the 100% brightness level. If the light doesn't come on, the battery is dead or damaged. Releasing the lens will switch the unit back into normal operation.

The EL500 unit can be operated in Six different modes.
All of the above plus Smoke Alarm Signal ON - When the EL500 receives a signal from a connected smoke alarm or security system, the power failure light will flash ON and OFF continuously at one-second intervals until the alarm signal is removed, or until the battery is drained (4 hours for a fully charged battery).

Cat # Description Spec's Quantity Discount Purchase

EL100 In-Wall Power Failure Light View 1-11 $32.25 12+ $30.63

EL500 Commercial Grade View 1-11 $38.70 12+ $36.76

EL500E Commercial Grade with Red Chevron Lens View 1-11 $38.70 12+ $36.76

Cat # Description Color Quantity Discount Purchase

EL200IV Power Failure Light with Receptacle Ivory 1-5 $32.25 12+ $30.63

EL200LA Power Failure Light with Receptacle Light Almond 1-5 $32.25 12+ $30.63

EL200WH Power Failure Light with Receptacle White 1-5 $32.25 12+ $30.63

Cat # Description Color Quantity Discount Purchase

EL300IV Power Failure Light with 1 Pole Switch Ivory 1-5 $32.25 12+ $30.63

EL300LA Power Failure Light with 1 Pole Switch Light Almond 1-5 $32.25 12+ $30.63

EL300WH Power Failure Light with 1 Pole Switch White 1-5 $32.25 12+ $30.63

Click on Pictures For Pricing and Product selection
Low Voltage	Transformers, Wire and Bulbs	Solar Lighting	Specialty Products	Mosquito Inhibitor
Click on Pictures For Pricing and Product selection
Spring Wound	Electronic Auto-Off	Heavy Duty Timers	Pool Timers	Photo Cells
Click on Pictures For Pricing and Product selection
Dusk-to-Dawn	Intermatic HID Lighting	Surge Protectors	Home Control	In-Use Covers